1600KG DIY Off Road Trailer Kit. Outback Springs, 10" J/Wheel, Poly Coupling

SKU : 190923959407
$1,300.00

Available



Details

DIY OFF ROAD TRAILER KIT
OUTBACK OFF ROAD SPRINGS
1600KG RATED

  

Stud Patterns Availble
6 STUD LANDCRUISER (6/139.7 PCD, 1/2" STUDS AND NUTS)
5 STUD LANDCRUISER (5/150 PCD, 9/16" STUDS AND NUTS)
FORD (5/114.3 PCD, 1/2" STUDS AND NUTS)

 

IN THIS KIT
1X 50MM SQUARE 1600KG PARALLEL SOLID AXLE WITH ELECTRIC BRAKE MOUNTS WELDED, ALSO COMES WITH SPLIT PINS & WASHERS.
AXLE TAKES APPROX 5 BUSINESS DAYS TO ENGINEER( can be supplied in any length up to 2500mm tip to tip or 2383mm hub face to hub face)
2X 7 LEAF 60MM X 7MM OFF ROAD BLACK SPRINGS WITH DAMPNERS (SPRINGS ARE SHOT PEENED FOR EXTRA STRENGTH)
2X FRONT HEAVY DUTY HANGERS
2X REAR EYE HANGERS WITH EXTRA STRENGTH WELD IN BRACKETS
2X OFF ROAD FISH PLATES
4X OFF ROAD 50MM X 150MM 5/8" HIGH TENSILE U BOLTS WITH NUTS AND WASHERS
2X HIGH TENSILE REAR DOUBLE SHACKLE BOLT SETUPS (WITH GREASE NIPPLES)
2X HIGH TENSILE FRONT SHACKLE PINS WITH GREASE NIPPLES
2X AXLE PADS
1X LEFT HAND 10" BRAKE BACKING PLATE WITH HAND BRAKE LEVER
1X RIGHT HAND 10" BRAKE BACKING PLATE WITH HAND BRAKE LEVER
2X 10" PARALLEL HUB DRUMS WITH CUPS ALREADY PRESSED IN (AVAILABLE IN FORD, 6 AND 5 STUD LANDCRUISER)
2X PARALLEL BEARING SETS INCLUDING DUST CAPS AND DUST SEALS
2 X DROP DOWN CORNER STEADIES WITH SWINGING BIG FOOT FOR STABILITY
1X CORNER STEADY HANDLE
1X 10" SWING UP JOCKEY WHEEL
1X WELD ON POLY BLOCK OFF ROAD COUPLING WITH HARD CHROME SHAFTING
1X POLY BLOCK CAR ADAPTOR AND SPRING PIN
1X QUICK RELEASE HANDBRAKE LEVER
8 METRES 4MM HANDBRAKE CABLE (LET US KNOW IF LONGER IS REQUIRED)
1X CABLE ADJUSTER
2X CABLE CLAMPS

ON PURCHASING PLEASE PROVIDE YOUR AXLE LENGTH AND STUD PATTERN

 

EXTRAS AVAILABLE
2" OR 4" DROP AXLES $295
JAPANESE KOYO BEARINGS $40 (CLICK ON LINK BELOW)
ASSEMBLE OF AXLE $50 PER AXLE

 

 

BEARING OPTIONS

UPGRADE TO JAPANESE BEARINGS $40.0 (CLICK ON LINK BELOW)

 

"CLICK HERE TO UPGRADE TO JAPANESE MANUFACTURED BEARINGS"

 

Long Part of spring to the front, move rear hanger 25mm towards the rear,

Centre to centre of the hangers needs to be 25mm greater than centre to centre of the springs


SHOT PEENING

Shot peening is a cold working process used to produce a compressive residual stress layer and modify mechanical properties of metals and composites. It entails impacting a surface with shot with force sufficient to create plastic deformation. Shot peening is often called for in aircraft repairs to relieve tensile stresses built up in the grinding process and replace them with beneficial compressive stresses